Spare silicone inhalation valve for 3M series 7500 respirators, model 7582

A reliable solution to extend the life of your 3M respirator mask

Manufacturer 3M, model 7582

The replacement silicone inhalation valve for 3M 7500 series masks is an official part designed to restore the effectiveness of the filtration system. It allows you to replace a worn or damaged valve without having to change the entire mask. Compatible exclusively with 7500 Series half masks, this replacement part ensures optimal respiratory protection against particles, gases, and vapors. By choosing a 3M-certified part, you guarantee compliance with current safety standards while extending the life of your equipment. Sold in packs of 10 units.

Compatible with masks:

• (R7501)
• (R7502)
• (R7503)

Essential Replacement Part for Respiratory Protection.

Key Features of the 3M 7582, 7500 Series Silicone Inhalation Valve

Crafted from flexible and resilient silicone, this valve offers excellent sealing properties and smooth airflow during inhalation. It is precision-molded to fit the designated slot in the 3M 7500 Series mask, ensuring a secure and leakproof installation. The valve’s responsive design opens and closes efficiently with each breath, preventing contaminants from entering while supporting natural respiration.

How to Install the 3M 7582 Replacement Inhalation Valve

Installing the 3M 7500 Series inhalation valve is quick and tool-free. First, remove the old valve carefully from the mask’s inlet port. Align the new silicone valve with the designated groove and press gently until it clicks into place. Ensure the valve is seated correctly to maintain airtight performance. Always test the mask’s seal before use to confirm proper installation.

Maintenance Tips for Your 3M 7582 Inhalation Valve

To keep your respirator functioning at peak performance, inspect the inhalation valve regularly. Clean it with a dry, lint-free cloth after each use, avoiding harsh chemicals or solvents. If the silicone shows signs of wear, cracking, or loss of elasticity, replace it immediately with a certified 3M valve. Proper maintenance ensures long-term respiratory protection and compliance with workplace safety standards.

Usage Guidelines for Optimal Respiratory Safety

Use this inhalation valve exclusively with 3M 7500 Series half-face respirators. Before each use, check that all components—including the valve, filters, and mask body—are intact and properly fitted. This valve is suitable for environments with airborne particles, chemical vapors, or biological hazards. For complete protection, pair the mask with appropriate 3M cartridges and filters based on your specific exposure risks.

FAQ 3M 7582, 7500 Series Inhalation Valve

How often should I replace the inhalation valve on my 3M 7500 Series mask?

 It depends on usage frequency and exposure conditions. Inspect the valve after each use and replace it if any damage or deformation is visible.

Is this valve compatible with other 3M respirator models?

No, this silicone inhalation valve is designed exclusively for the 3M 7500 Series half-face respirators and should not be used with other models.

Additional suggestions about the 3M 7500 Series Inhalation Valve

Need additional safety equipment? See the following items: CDN “Cartridge Respirator Required” sign (ECO106), “Notice: Cartridge Respirator Required in This Area” sign (EOAV328), Replacement suspension headband (R7581) and the exhalation valve (R6583).

Under “Accessories” at the bottom of the page. If you are looking for work equipment, check out the following products: Alcohol-free cleaning wipes for protective masks (R504), NIOSH-approved P100 filter for 3M respirator masks (R7093) or cotton painter's hood (VF1410).

The green text corresponds to hyperlinks leading to specific safety equipment or general information.